Furuno WR-2100 Operator's Manual page 30

Setting
Scale:
Setup a distance of scale into a pop-up window of
[Scale]
Azimuth offset:
Setup a degree of offset into a pop-up window of
[Azimuth Offset]
Disp
Select：
Select an indication of data type：
- Rain： Intensity of rainfall
- Zhh： Reflection factor of the horizontal polar-
imetric radar
- Zvv：Reflection factor of the vertical polar-
imetric radar
- V： Doppler velocity
- Zdr： Radar reflection factor difference
- Kdp： Propagation phase difference rate of
change
- Φdp: Differential Phase Shift
- ρｈｖ: Polarimetric Correlation Coefficient
- W: Doppler velocity spectral width
Ratio of transparency [%]:
Setup a Transmittance of the indication echo.
Map：
Output a map from input file (*.bmp)
SRHI screen：
・ 90 deg screen (Indicate the echo of SRHI
with 90 degrees)
・ 180 deg screen (Indicate the echo SRHI with
180 degrees)
Invalid data area:
Turn ON/OFF the indication of invalid data area.
Signal shading area:
Select the indication of signal shading area.
OFF: Hidden, 1: Grayed out, 2: Gray scale
Signal extinction area:
Select the indication of signal extinction area beyond
strong rain area.
OFF: Hidden, 1: Grayed out, 2: Gray scale
Ground clutter rejection area:
Select the indication of ground clutter
rejection area.
OFF: Hidden, 1: Grayed out, 2: Gray scale
Ground clutter rejection level:
Select the level of ground clutter rejection
from 0 to 7
Pulse blind area:
Select the indication of pulse blind area.
OFF: Hidden, 1: Grayed out, 2: Gray scale
Sector blank:
Select the indication of sector blank.
OFF: Hidden, 1: Grayed out, 2: Gray scale
Clear：
Data of Rain file will be cleared from screen
23
SSE-14-0022_17