Usb Port Cover Installation; Usb Cover Finished Installation - Cisco IR1101 Hardware Installation Manual

Figure 11

USB Port Cover Installation

7. Tighten the latch lock screw to a torque of 2.8 to 3.8 inch-lbs (0.3 to 0.4 newton meter). Refer to
finished USB cover installation.
Figure 12

USB Cover Finished Installation

8. Slide the Pluggable Module into the device as shown in
hole (2) on the front of the device. Push the Pluggable Module all the way into the device until you feel it seat, and
then torque the latch lock screw 8-10 inch-pound (0.9 to 1.1 newton meter).
Figure 13. The latch lock screw (1) aligns with the screw
36
Figure 12 for a