Installing Antennas; Items Shipped With Your Router; Additional Items; Ethernet Devices - Cisco IR1101 Hardware Installation Manual

Items Shipped with your Router

Unpack the box and verify that all items listed on the invoice were shipped with the Cisco IR1101.
The following items are shipped with your router:

Getting Started/Product Document of Compliance

Grounding Lug Kit

Power Connector

Additional Items

The following items are not shipped with the router but are required for installation:

ESD-preventive cord and wrist strap.

Wire crimper for chassis grounding.

Wire for connecting the chassis to an earth ground.

Ethernet cables for connecting to the Fast Ethernet (FE) WAN and LAN ports.

Ratcheting torque flathead screwdriver that exerts up to 15 in-lb (1.69 N-m) of pressure.

A number-2 Phillips screwdriver.

Ethernet Devices

Identify the Ethernet devices that you will connect to the router: hub, servers, and workstations or PCs. Ensure that each
device has a network interface card (NIC) for connecting to Ethernet ports.
Installing the Router
This section describes how to install the Cisco IR1101. This router can be installed in the following ways:

Table top

Flat horizontal surface

Mounted on a wall

Using a DIN rail
Warnings
WARNING: For NEC-compliant grounding, use size 16awg (1.5mm2) or larger copper wire and a ring terminal with an
inner diameter of 1/4 in. (6 to 7mm).

Installing Antennas

NOTE: Before you install the Cisco IR1101 Integrated Services Router on a table, wall, or DIN rail, install the antennas on
the Pluggable Module. It is difficult to install the antennas after the router is installed.
26