Supported Cisco Antennas And Cables; Reset Button; Lte-Antm-Sma-D; Ant-4G-Pnl-Out-N - Cisco IR1101 Hardware Installation Manual

Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
Cisco 1100 Series Software Configuration Guide
Highlights of the LTE Pluggable Module are:

All Wireless interfaces are supported through a Pluggable Module

Micro-Sim, 3FF size, Industrial Temperature range of -40C to +105C

Reset Button

The Reset button resets the router configuration to the default configuration set by the factory. To restore the router
configuration to the default configuration set by the factory, use a standard size #1 paper clip with wire gauge 0.033 inch
or smaller and simultaneously press the reset button while applying power to the router.

Supported Cisco Antennas and Cables

The IR1101 must have an expansion module with antenna ports installed in order to connect antennas. The base unit
does not have any wireless capabilities on its own.
The following section lists the supported Antennas and Cables for the Cisco IR1101 with a wireless Pluggable Module.
For detailed information about Cisco Antennas for the Industrial Routers, please refer to the following guide:
Cisco Industrial Routers and Industrial Wireless Access Points Antenna Guide:
http://www.cisco.com/c/en/us/td/docs/routers/connectedgrid/antennas/installing-combined/industrial-routers-and-i
ndustrial-wireless-antenna-guide.html
The following antennas and cables are available:

LTE-ANTM-SMA-D

Omnidirectional 4G/LTE Swivel Mount Dipole antenna designed for indoor use with Cisco 4G Long Term Evolution (LTE)
routers and modules with an SMA(f) connector. Articulating Joint which can be rotated 360 degrees and is capable of
maneuvering into three stop positions: 0 degrees, 45 degrees, and 90 degrees. Male sub-miniature A (SMA) Connector
which allows direct mounting of the antenna to any Cisco supported router with a female SMA connector. The
LTE-ANTM-SMA-D antenna is marked with a dual green band to indicate that it supports Cisco LTEA routers and
modules.
This antenna has the following features:

Support for frequencies of 698-960, 1448-1511, and 1710-2690 MHz.

Standalone antenna peak gain of less than 3.7 dBi in the supported frequency bands.

Articulating joint that can maneuver into three stop positions: 0°, 45°, and 90°.

Male SubMiniature A connector that allows direct mounting of the antenna to any Cisco supported router or
Pluggable Module with an SMA connector.

The SMA connector design has added rotational frictional torque to ensure the SMA interface stays properly mated,
and to reduce chances of a disconnect. The design is also more finger friendly compared to a classic SMA hex nut
design.

ANT-4G-PNL-OUT-N

Cisco Multiband Panel Outdoor 4G MIMO dual port antenna, designed to cover cellular 4G bands.
The supported bands are:
18