Installing The Router; Equipment, Tools, And Connections - Cisco IR1101 Hardware Installation Manual

Installing the Router

This chapter describes the equipment and the procedures for successfully installing the Cisco IR1101 and contains the
following sections:

Equipment, Tools, and Connections, page 25

Installing the Router, page 26

Installing Antennas, page 26

Mounting on a Wall, Table, or Other Flat Surface, page 27

Installing a DIN Rail, page 30

Installing the Router Ground Connection, page 33

Pluggable Module, page 34
CAUTION: Do not install the router or power supplies next to a heat source of any kind, including heating vents.
WARNING: Read the installation instructions before connecting the system to the power source. Statement 1004
WARNING: Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
WARNING: Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
WARNING: Do not locate the antenna near overhead power lines or other electric light or power circuits, or where it can
come into contact with such circuits. When installing the antenna, take extreme care not to come into contact with such
circuits, because they may cause serious injury or death. For proper installation and grounding of the antenna, please
refer to national and local codes (for example, U.S.:NFPA 70, National Electrical Code, Article 810, Canada: Canadian
Electrical Code, Section 54). Statement 1052
WARNING: No user-serviceable parts inside. Do not open. Statement 1073
WARNING: This product is not intended to be directly connected to the Cable Distribution System. Additional regulatory
compliance and legal requirements may apply for direct connection to the Cable Distribution System. This product may
connect to the Cable Distribution System ONLY through a device that is approved for direct connection. Statement 1078
WARNING: A minimum of 1 inch clearance is required on all sides of the product when mounting in either horizontal or
vertical orientation. Stacking heat-dissipating objects on top of the router is not allowed. I/O side clearance is needed
as it is required to access the cable connections. Clearance is required to attach, mount the DIN rail bracket, and Wall
mount bracket.

Equipment, Tools, and Connections

This section describes the equipment, tools, and connections necessary for installing your Cisco IR1101.
Note: No antenna is shipped with the IR1101 by default.
Cisco Systems, Inc. www.cisco.com
25