Installing Antennas - Cisco IR809 Installation Instructions Manual

Installing the Router
Product
MC7350
MC7354
MC7304

Installing Antennas

There are two TNC connectors on the backside of the device. The TNC connectors are used to connect to the
4G modem. The SMA connector is for the GPS antenna.
Orient the antennas. For optimum wireless performance, the antennas should be perpendicular with respect
to the floor.
If the router is being mounted on a desk, orient the antennas straight up.
To attach the radio antennas to your wireless router, follow these steps:
Before You Begin
Before you install the Cisco 809 Integrated Services Router on a table, wall, or DIN rail, install the antennas
on the back panel. It is difficult to install the antennas after the router is installed.
In some cases it is necessary to install two antennas:
Modem Chipsets Carrier
MDM9615 Verizon
WTR1605L Sprint
PM8018
MDM9215 ATT
WTR1605L Canada
PM8018
MDM9215 Europe
WTR1605L New Zealand
PM8018 Australia
Cisco 809 Industrial Integrated Services Router Hardware Installation Guide
2G 3G (Diversity)
BC0 - CDMA BC0 - CDMA
-800 -800
BC1 - CDMA - BC1 - CDMA -
1900 1900
BC10 - CDMA BC10 - CDMA
-800 -800
Quad GSM B2 - UMTS
1900
B4 - UMTS
AWS
B5 - UMTS 850
Quad GSM B1 - UMTS
2100
B2 - UMTS
1900
B5 - UMTS 850
B6 - UMTS 800
B8 - UMTS 900
Installing Antennas
4G (MIMO)
B4 - UMTS
AWS
B13 -
UMTS-700
B25 - PCS 1900
B2 - UMTS
1900
B4 - UMTS
AWS
B5 - UMTS 850
B7 -
UMTS-2600
B17 -
UMTS-700
B1 - UMTS
2100
B3 - UMTS
1800
B7 -
UMTS-2600
B8 - UMTS 900
B20 - UMTS -
E800
5