Second Edition - First Printing
FAULTS AND TROUBLESHOOTING
This chapter represents a practical guide for the
operator for fixing the most common failures and, at
the same time, detecting those interventions that must
be carried out by qualified technical engineers.
If you are unsure about anything, do not carry out
operations on the machine, but call in a skilled
technician.
PROBLEM
THE DASHBOARD
DOES NOT TURN ON
THE STARTER DOES
NOT RUN
THE STARTER RUNS,
BUT THE ENGINE
DOES NOT START
THE MACHINE
DOES NOT MOVE
FORWARD/BACK
NO SELECTION
OF THE STEERING
MODE
THE DLE LOAD
LIMITING SYSTEM IS
IN ALARM
Part No. 57.0009.0454
Faults and Troubleshooting
CAUSES
•
Battery down
•
Fuse in the engine
compartment box blown
•
Forward/reverse gear selector
not in neutral position
•
Battery down
•
Engine start fuse blown:
(GTH-4514 EX & GTH-4017
EX); F1M (GTH-4013 EX)
•
No fuel
•
Fuel filter clogged
•
Fuel hose empty (fuel used up)
•
Changeover switch in neutral
•
Parking brake engaged
•
Fuse
F14 blown
•
Fuse
F13 blown
• Fuse F25 blown
• System failure
GTH-4013EX - GTH-4514EX - GTH-4017EX
WARNING
Any repair work, maintenance or troubleshooting
must be carried out with machine stopped, boom
in rest position or laid on the ground, parking
brake engaged and ignition key removed.
SOLUTIONS
•
Check the battery condition
•
Check the main fuse in the engine
compartment and replace if
necessary
•
Set the switch to
•
Recharge or replace the battery
F56
•
Check the fuse located i and
replace if necessary
•
Refuel
•
Change the filter. See engine
operator handbook)
•
Refuel, then refer to engine
operator handbook
•
Set the gear switch to correct
position
•
Disengage
•
Check the fuse and replace if
necessary.
•
Check the fuse and replace if
necessary.
•
Check and replace fuse, if necessary
•
Check the load cell functionality
Operator's Manual
0
99
Courtesy of Crane.Market