Husqvarna R135 Workshop Manual page 7

1
E
D
C
B
A
6
Starter
Assemble the starter pulley.
Position the start assistance spring in
position in the starter pulley and assem-
ble the other parts as in the illustration.
Tighten the screw in the centre of the
starter pulley.
502 50 64-01
Lubricate the spindle with a little grease
and fi t the starter pulley.
Move the starter cord through the guide
in the starter housing.
Place the start assistance spring (A) in
position.
Position the cover disc (B) over the start
assistance spring and make sure that
the spring pin enters the disc correctly.
Place the spacer (C) and washer (D) in
position in the hub on the cover disc (B).
Tighten the screw (E) in the centre of
the starter pulley.
Assemble the starter handle.
Tie a double knot on the starter cord and
fold under the free end.
Pull the knot fully into the handle.