Husqvarna R135 Workshop Manual page 45

5
333/335
(model L och RJ)
44
Angle gear
336
Model 333/335
On models with a two-piece shaft, the
guide becomes accessible once the
shaft has been split (see chapter 3).
Dismantle the sleeve (A) and pull out
the guide (B) by pulling the drive axle.
Model 336
Loosen the turn handle (A) and both
screws (B). Press down the locking
spring (C) and seperate the shaft.
Pull out the drive axle (D) and remove
the sleeve (E) with the help of a screw-
driver. This makes the guide for the
drive axle (F) accessible if it must be
replaced.
Assembling
Lubricate the drive axle with grease no.
503 80 17-01 when assembling in the
guide.
503 80 17-01