Husqvarna R135 Workshop Manual page 28

Fuel system
Check that the carburettor is sealed.
No leakage is permitted at 50 kPa.
531 03 06-23
Attach the control diaphragm and cover.
Fit the jet needles and adjust their set-
ting.
Model H L
135 2.0 0.75
333 2.0 (EL-36D) 1.0 (EL-36D)
335 2.0 (EL-36D) 1.0 (EL-36D)
336 2.0 0.75
535 2.0 (EL-36D) 1.0 (EL-36D)
NOTE!
The H-needle is a little shorter
than the L-needle.
Press the stop plugs (A) in position
using tool 504 62 29-01. Check that the
O-ring is correctly seated and that the
slot in the plug aligns with the ball (B) in
the carburettor housing.
504 62 29-01
Connect pressure tester 531 03 06-23
to the fuel intake on the carburettor.
Pump up the pressure to 50 kPa.
Lower the carburettor in a vessel with
petrol in order to discover any leaks
more easily.
No leakage is permitted.
Place the gasket on the carburettor
housing and then the control diaphragm.
Check that the air hole in the cover is
open and screw the cover on.
3
27