Husqvarna 525RJX Operator's Manual
  1. Manuals
  2. Brands
  3. Husqvarna Manuals
  4. Brush Cutter
  5. 525RJX
  6. Operator's manual

Husqvarna 525RJX Operator's Manual

Hide thumbs Also See for 525RJX:
Table of Contents

Advertisement

Quick Links

Download this manual
525RJX
EN
Operator's manual
2-26

Advertisement

Table of Contents
loading

Related Manuals for Husqvarna 525RJX

Summary of Contents for Husqvarna 525RJX

  • Page 1 525RJX Operator's manual 2-26...

  • Page 2: Table Of Contents

    Contents Introduction..............2 Transportation, storage and disposal......22 Safety................4 Technical data.............. 22 Assembly..............10 Accessories..............23 Operation..............13 Declaration of Conformity..........25 Maintenance..............17 Appendix ..............27 Troubleshooting............21 Introduction Product description Intended use The product is a grass trimmer with a combustion The product is used with a trimmer head to cut grass.
  • Page 3 3. Bevel gear 4. Cutting attachment guard The product can cause objects to eject, 5. Shaft which can cause injury. 6. Loop handle 7. Throttle trigger Keep a minimum of 15 m distance to 8. Stop switch persons and animals during operation of 9.

  • Page 4: Safety

    The rating plate shows the • the product is repaired with parts that are not serial number. yyyy is the from the manufacturer or not approved by the yyyywwxxxx production year, ww is the manufacturer. production week. • the product has an accessory that is not from the manufacturer or not approved by the manufacturer.
  • Page 5 • The only accessories you can operate with this • Keep the cutting attachment below waist level. engine unit are the cutting attachments that we • Switch off the engine before you move to another Accessories on page 23 . recommend.
  • Page 6 equipment cannot fully prevent injury but it • Use protective boots with steel toes and non-slip decreases the degree of injury if an accident does soles. occur. Let your dealer help you select the right equipment. • Use a protective helmet where there is a risk of falling objects.
  • Page 7 machine is not a servicing dealer, ask him 5. Start the product (refer to the instructions under for the address of your nearest service start the product on page 15 ) and apply full throttle. agent. 6. Release the throttle and make sure that the cutting attachment stops and remains at a standstill.
  • Page 8 also prevents injuries that occur if you touch the cutting 3. Make sure that the vibration damping units are attached correctly. attachment. 1. Make sure that the cutting attachment guard is not damaged or cracked. 2. Replace the guard if it has been exposed to impact To do a check of the muffler or is cracked.
  • Page 9 Cutting equipment Trimmer head • Use the blades and grass knives to cut coarse grass. WARNING: Always make sure the trimmer line is wound tightly and evenly around the drum to prevent harmful vibration. • Use the trimmer head to cut grass. •...

  • Page 10: Assembly

    • Always stop the engine and let it cool off for a few attachment has stopped completely and minutes before you refuel. disconnect the spark plug before you start to work on it. • Open the fuel cap slowly so that any excess pressure is released gently when you refuel.
  • Page 11 To install the suspension ring 7. Turn the trimmer head /plastic blades (H) in the opposite direction from which the trimmer head/ 1. Install the suspension ring to the shaft between the plastic blades rotates. rear handle and the loop handle. To disassemble the cutting attachment 2.
  • Page 12 To attach and remove the locknut be replaced after it has been put on approximately 10 times. WARNING: Stop the engine, use To attach the grass blade and the protective gloves and be careful around the grass blade guard/combination guard sharp edges of the cutting attachment.

  • Page 13: Operation

    Use a mixture of of dangerous remainings when it is combusted, which gasoline and two-stroke oil. keeps the components of the engine more clean. This extends the life of the engine. Husqvarna alkylate fuel is Gasoline not available in all markets. Two-stroke oil...
  • Page 14 0.30 0.40 To mix gasoline and two-stroke oil CAUTION: There is a risk that small errors influence the ratio of the mixture drastically when you mix small quantities of fuel. Carefully measure the quantity of oil CAUTION: Contamination in the tanks to be mixed to make sure that you get the causes malfunction.
  • Page 15 • Make sure that the locknut can not be removed by 2. Move the choke control up into choke position. hand. If you can remove it by hand, it does not lock the cutting attachment sufficiently and you must replace it. •...
  • Page 16 • Start the movement from right to left when you cut. Note: If the engine stops, do the procedure again. Move the product to the right before you cut again. • Cut with the left side of the grass blade. To stop the product •...

  • Page 17: Maintenance

    4. Use 80 % throttle when you cut grass near objects. 2. Do not push the trimmer head to the ground. This can cause damage to the product. 3. Move the product from side to side when you cut grass. Use full speed. To use the grass clearing technique •...
  • Page 18 Bevel gear on Make sure that the bevel gear is filled correctly with grease, see page 21 . If not, use Husqvarna bevel gear grease. Clean or replace the spark arrestor mesh on the muffler (only applies to mufflers without a catalytic converter).
  • Page 19 Note: Technical data on page 22 for the Refer to recommended idle speed. To do maintenance on the trimmer head 1. Only use the recommended cutting attachment and Accessories on cutting attachment guard. Refer to page 23 . 2. Make sure that the cutter on the cutting attachment guard is not damaged, it cuts the cord to the correct length.
  • Page 20 you touch the product it can result in burns a) Make sure that the idle speed is correctly to the skin. Think about of the risk of fire. adjusted. b) Make sure that the fuel mixture is correct. c) Make sure that the air filter is clean. 1.

  • Page 21: Troubleshooting

    But, before you use the product, make sure that the bevel gear is 3/4 full with grease. Use Husqvarna special grease. 3. Clean the air filters with warm soap water. 4. Replace the air filters if they cannot be fully cleaned.

  • Page 22: Transportation, Storage And Disposal

    • When the product is no longer in use, send it to • Ensure that the product is cleaned and that a a Husqvarna dealer or discard it at a recycling complete service is carried out before long-term location. storage.

  • Page 23: Accessories

    525RJX Ignition system Manufacturer/type of ignition system IKEDA/UK Spark plug NGK BPMR8Y Electrode gap, mm 0.65 Fuel and lubrication system Manufacturer/type of carburetor Walbro WTEA-8C Fuel tank capacity, liter 0.51 Weight Without fuel, cutting attachment and guard, kg Noise emissions...
  • Page 24 Approved accessories Accessory type Cutting attachment guard, art. no. Blade shaft thread M10 Plastic blades Tricut Ø 300 mm 503 93 42-02 / 588 11 79-01 Grass blade/grass cutter Grass 255-4 (Ø 255 4-teeth) 503 93 42-02 / 588 11 79-01 Superauto II 1"...

  • Page 25: Declaration Of Conformity

    Declaration of Conformity EC Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Brush cutter Brand Husqvarna Type / Model 525RJX Identification Serial numbers dating from 2016 and onwards...
  • Page 26 UK Declaration of conformity We, Husqvarna AB, SE-561 82 Huskvarna, Sweden, tel: +46-36-146500, declare on our sole responsibility that the product: Description Brush cutter Brand Husqvarna Type / Model 525RJX Identification Serial numbers dating from 2022 and onwards complies fully with the following UK regulations:...

  • Page 27: Appendix

    Tri Cut 6 Nm x 10 1927 - 001 - 10.06.2022...
  • Page 28 Alloy ø 2,0 - 2,4 mm/ .080-.095" ø 2,0 - 3,3 mm/ .080- .130" 550 mm/ 22" 1927 - 001 - 10.06.2022...
  • Page 29 Super Auto II Super Auto II 1 " 4,0 m 15 cm ~2,0 m 6 " 6,5 ' 15 cm 6 " 1927 - 001 - 10.06.2022...
  • Page 30 6,0 m 10 cm 4" 3,05 m "Clic" 15 cm 6" 1927 - 001 - 10.06.2022...
  • Page 31 T35, T35x 8,5 m 10 cm 4" 4,3 m "Click" 15 cm 6" 1927 - 001 - 10.06.2022...
  • Page 32 Original instructions 1154813-26 2022-06-20...

Table of Contents