Husqvarna R135 Workshop Manual page 27

3
26
Fuel system
Attach the various parts of the
measuring unit in the reverse order as
set out for dismantling.
The lever arm should lie fl ush with the
carburettor housing.
• Mount the valves and dampers.
Replace the fuel screen if it is damaged
or cannot be cleaned.
Place the pump diaphragm closest
to the carburettor housing. Then
the gasket and cover and the other
components in reverse order of
removal.
NOTE!
Check that the valves are turned
correctly and that they close
completely and tightly in the
closed position.
Use Loctite on the valve screws.
Attach the various parts of the
measuring unit in the reverse order as
set out for dismantling.
The lever arm should lie fl ush with the
carburettor housing.
Too high setting = too much fuel.
Too low setting = too little fuel.