Quick Start Guide
Product certifications
Potential electrostatic charging hazard
To prevent the risk of electrostatic sparking, the surface of the glass-filled nylon (plastic) enclosure should
only be cleaned with a damp cloth.
Do not directly install in any process where its enclosure might be charged by the rapid flow of
non-conductive media.
7.0
European Union directive information
The EU Declaration of Conformity begins on
revision can be found at Emerson/Rosemount.com.
Note
A safety isolator such as a zener barrier is needed for intrinsic safety.
8.0
Factory Mutual (FM) approvals
Factory Mutual (FM) ordinary location approval
(on the Rosemount 3101 and 3102 Only)
G5 Project ID: 3024095
The transmitter has been examined and tested to determine that the design meets basic
electrical, mechanical, and fire protection requirements by FM, a nationally recognized
testing laboratory (NRTL) as accredited by the Federal Occupational Safety and Health
Administration (OSHA).
Factory Mutual (FM) intrinsically safe approval (on the Rosemount 3105 only)
I5 Project ID: 3024095
Intrinsically Safe for Class I, Division 1, Groups A, B, C, and D
Zone Marking: Class I, Zone 0, AEx ia IIC
Temperature Code: T6 (T
Temperature Code: T4 (T
Control Drawing: 71097/1216
Ui = 30 V, li = 120 mA, Pi = 0.82 W, Li = 108 μH, Ci = 0 nF.
Factory Mutual (FM) non-incendive approval (on the Rosemount 3105 only)
I5 Project ID: 3024095
Non-Incendive for Class I, Division 2, Groups A, B, C, and D
Zone Marking: Class I, Zone 2, AEx nA IIC
Temperature Code: T6 (T
Temperature Code: T4 (T
Control Drawing: 71097/1216
Ui = 30 V, li = 120 mA, Pi = 0.82 W, Li = 108 μH, Ci = 0 nF
24
= 55 °C)
a
= 60 °C)
a
= 55 °C)
a
= 60 °C)
a
page 28
and the most recent
September 2018