Thermador Masterpiece Series Use And Care Manual page 26

Inserting the Meat Probe into the Food
Before placing your food into the oven cavity, insert the
meat probe into the food.
The meat probe has three measuring points. Ensure that
the middle measuring point is inserted in the food.
Meat: For large pieces of meat, insert the meat probe at
an angle from above as far as it will go into the meat.
For relatively thin pieces of meat, insert the meat probe
from the side at the thickest point.
Steam Oven Cavity:
Conventional Oven Cavity:
Poultry: Insert the meat probe as far as it will go into the
thickest point in the breast. Insert the meat probe into the
poultry crosswise or lengthwise depending on its
structure. Put the chicken in a roasting dish and place it
on the wire rack.
Turning the food: If you wish to turn the food, do not
unplug the meat probe from the oven. Once you have
turned the food, check that the meat probe is correctly
repositioned in the food.
If you unplug the meat probe from the oven, all settings
will be reset and you will have to apply them again.
26
NOTICE: Ensure that the meat probe's cable does not
become trapped.
To prevent the meat probe from being damaged by
excessive heat, there must be a gap of at least an inch or
more between the broil element and the meat probe. The
meat may expand during the cooking process.
Setting and Starting Appliance Operation
WARNING
9
RISK OF BURNS
The oven interior and the meat probe become very
hot. Use oven mitts to plug and unplug the meat
probe.
WARNING
9
RISK OF ELECTRIC SHOCK
Use of a wrong meat probe can damage the
insulation. Use only the meat probe intended for this
appliance.
Notes
The set oven cavity temperature must be at least
▯
50° F (10 °C) higher than the meat probe
temperature.
To prevent the meat probe from being damaged, the
▯
oven cavity temperature must not be set higher than
480° F (250 °C).
Insert the meat probe into the socket on the left-hand
1.
side of the oven cavity.
Note: The probe icon will appear on the oven display
screen.
Close the appliance door.
2.
NOTICE: When doing so, ensure that the meat
probe's cable is not trapped in the appliance door. It
may be damaged.
Touch the ON l OFF touch button.
3.
Set the heating mode.
4.
Note: When the meat probe is plugged into the
socket, you can only select a heating mode that is
suitable to be used with the meat probe.
Touch the oven cavity temperature on the left in the
5.
bottom line.
Swipe to the left or right to select the required oven
6.
cavity temperature.
Touch the symbol to apply the setting.
8
7.
Touch the core temperature on the right in the
¥
8.
bottom line.
Swipe to the left or right to select the required core
9.
temperature.
Touch the START l STOP touch button.
10.
The appliance starts the operation.