Siemens SIMATIC PC 670 Equipment Manual page 98

Configuring the Computing Unit in BIOS Setup
Submenu "Boot Options"
The following submenu appears when you select the option "Boot Options" in
the main menu:
QuickBoot Mode:
SETUP prompt:
POST Errors:
Floppy check:
Summary screen:
F1
ESC
Figure 5-5
Quick Boot
Mode
SETUP prompt
POST Errors
5-10
PhoenixBIOS Setup Utility
Main
Boot Options
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Enabled]
Help Select Item
Exit Select Menu
"Boot Options" Submenu
Some hardware tests are skipped when the system starts up, thus
speeding up the boot procedure.
The message PRESS <F2>
the screen during the system load phase.
The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter "Disabled"to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.
Item Specific Help
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
+ / – Change Values F9
Select
Enter Sub-Menu F10
to enter Setup
appears at the bottom of
Panel PC 670 Computing Unit, Equipment Manual
Release 04/02
Setup Defaults
Save and Exit