Scsi-To-Fibre Channel Mapping Configuration; Trace Settings Configuration - Siemens PSFR-CP41 Installing, Starting Up And Maintaining

Configuring the PSFR-CP41
Current Fibre Channel to SCSI Mapping Mode is Indexed
1) Display Attached SCSI Devices, LUN Priority
2) Display Attached SCSI Devices, Target ID Priority
3) Display Attached SCSI Devices, Bus Number Priority
4) Change the Fibre Channel to SCSI Mapping Mode
5) Show/Edit Fibre Channel to SCSI Mapping Table
X) Return to Previous Menu

SCSI-to-Fibre Channel Mapping Configuration

This option allows modification of the table mapping SCSI Target:LUN values to
Fibre Channel Node:LUN values.
Configuration of these devices is similar to that for indexed addressing, without
the user assists. Prior to configuring these tables, the user must enable the
SCSI target and initiator addresses desired to enable the mapping for that SCSI
device.
This is not used in Siemens Configurations.

Trace Settings Configuration

This option allows trace levels to be set. This should not be modified in normal
operation, as performance degradation may result.
Level 0 : ON
Level 2 : OFF
Level 4 : OFF
Level 6 : OFF
U) Update Current Operating Trace Levels
X) Return to previous menu
Further information on using this interface can be located in the troubleshooting
section of the manual.
U42093-J-Z716-1-74
Fibre Channel to SCSI Configuration Menu
Version: X.X XXXX
Trace Settings
Version: X.X XXXX
Level 1 : ON
Level 3 : OFF
Level 5 : OFF
Level 7 : OFF
Perform Configuration
Operating Manual