Autobaud Feature - Siemens PSFR-CP41 Installing, Starting Up And Maintaining

Mounting the PSFR-CP41 in a Rack
I
0
PSFR-CP41 Serial port

Autobaud Feature

The autobaud feature automatically configures the baud rate on the PSFR-
CP41. Once you set the baud rate in the terminal emulation program, wait until
the PSFR-CP41 completes the Power On Self Test (POST). This can take
approximately 25 seconds. Then press the Enter key five or six times and the
PSFR-CP41 will automatically detect the baud rate and configure the router.
The baud rate is then saved in the PSFR-CP41's configuration and will be
retained through future power cycles.
Hitting the Enter key before the POST has completed has no effect on
i
the autobaud feature. Wait until the POST has completed before hitting
the ENTER key.
The baud rate in the terminal emulation program must be set at 9,600, 19,200,
38,400, 57,600, or 115,200 for the autobaud feature to recognize it. The PSFR-
CP41 will not function properly at any other baud rate.
Operating Manual
Installing the PSFR-CP41
S erial port
U42093-J-Z716-1-74