Table of Contents
Advertisement
Page 6
What you should expect to find in the carton
Check to be sure that all of the following items have been included
in the carton along with this manual:
Clean Before Using
After you remove the unit from it s packaging, clean the inside be-
fore u sing. See cle aning instru ctions in the Cleaning section of
this manual.
1. Place cooler on a dry surface where it is protected from water.
2. The cooler should not be used where it may be exposed to rain.
3. Never locate the cooler where the ambient temperature is be-
ALLOW C OOLER T O SIT UPRIG HT FOR 24 HOURS BEFO RE
TURNING ON, TO ALLOW THE COMPRESSOR LUBRICANT TO
DRAIN.
Keep flammable materials and vapors such as gasoline away from
appliances. Failure to do so can result in fire or explosion.
Electrical Connection
The co oler can be op erated from eith er a DC or
source. Both req uire th e use of the DC/DC po wer cord in cluded
with the unit. With an
must be plugged into the end of the DC/DC power cord, then con-
nected to an AC source such as a wall socket.
DC Source: The cooler can be operated between 10.3V and 17V
AC Source: Be sure to use the AC/DC adapter when your power
SUMMIT APPLIANCE
Before First Use
1 compressor freezer, model SPRF26
1 DC/DC power cord
1 AC/DC adapter
Installation
low 0°C (32°F).
AC sou rce, the include d AC/DC adapte r
DC, or between 22V and 30V DC. Before connection, check
that the battery voltage falls within these ranges. If the voltage
is out of range, the cooler will not operate. Excessive voltage
could damage the electronic components of the cooler.
source is AC, otherwise the cooler could be damaged.
an AC po wer
Advertisement
Table of Contents
