Summit SPR488BOS User Manual

Beverage cooler

Advertisement

Quick Links

BEVERAGE COOLER
User Manual
Models:
Solid Door
Glass Door
FF195, BAR197, BCR199
SCR1931, BAR19, BC19
SPR196OS, BAR198S, BCR19S
SPR489OS, BAR191S, BC193S
SPR488BOS, SCR1932B
BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING
INSTRUCTIONS IN THIS MANUAL.

Advertisement

Table of Contents
loading

Summary of Contents for Summit SPR488BOS

  • Page 1 BEVERAGE COOLER User Manual Models: Solid Door Glass Door FF195, BAR197, BCR199 SCR1931, BAR19, BC19 SPR196OS, BAR198S, BCR19S SPR489OS, BAR191S, BC193S SPR488BOS, SCR1932B BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS IN THIS MANUAL.
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Appliance Safety Important Safeguards Location of Parts Installation Instructions Before Using your Appliance Installation of your Appliance Electrical Connection Installing the Door Handle Reversing the Door Swing Operating your Appliance Control Panel Door Lock Defrosting Shelves Care and Maintenance Cleaning your Appliance Power Failure Vacations...
  • Page 3: Appliance Safety

    APPLIANCE SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others.
  • Page 4 Disconnect from the electrical power line, Air the room in which the appliance is located for several minutes, and Contact the Service Department for advice. • The more coolant there is in an appliance, the larger the room it should be installed in. In the event of a leakage, if the appliance is in a small room, there is the danger of combustible gases building up.
  • Page 5: Location Of Parts

    LOCATION OF PARTS...
  • Page 6: Installation Instructions

    INSTALLATION INSTRUCTIONS Before Using your Appliance • Remove the exterior and interior packing. • Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.
  • Page 7: Installing The Door Handle

    Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For personal safety, this appliance must be properly grounded. This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
  • Page 8: Reversing The Door Swing

    Reversing the Door Swing (if desired)
  • Page 9: Operating Your Appliance

    OPERATING YOUR APPLIANCE It is recommended you install the appliance in a place where the ambient temperature is between 72º and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the performance of the unit may be affected. For example, placing your unit in extremely cold or hot conditions may cause interior temperatures to fluctuate.
  • Page 10: Care And Maintenance

    CARE AND MAINTENANCE Cleaning your Appliance • Turn off the power, unplug the appliance, and remove all items, including shelves. • Wash the inside surfaces with a solution of warm water and baking soda (about 2 tablespoons of baking soda to a quart of water). •...
  • Page 11: Troubleshooting

    TROUBLESHOOTING You can solve many common problems easily, saving you the cost of a possible service call. Try the suggestions below to see if you can solve the problem before calling the service technician. If you've checked the table above and find that you still need help with your appliance, call our Customer Service facility at 800-932-4267 between 9:00AM and 5:00PM ET.
  • Page 12: Limited Warranty

    LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factory- specified parts and repair labor to correct defects in materials or workmanship.

Table of Contents