Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
Before Using your Appliance
•
Remove the exterior and interior packing.
•
Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the door. (See page 7.)
Installation of your Appliance
•
The appliance is designed for free-standing or built-in installation
CAUTION: This appliance is designed for storing and cooling beverages and drinks. Do not store
perishable food, medicine or other medical products.
•
Place your Beverage Cooler on a floor that is strong enough to support it when it is fully loaded.
To
•
level the unit, adjust the front leveling legs.
•
For free-standing installation, leave 5 inches (127mm) of space around the back and sides of the
unit to allow proper air circulation to cool the compressor and condenser. Even for built-in
installation, it is a must to keep ¼" (6.35mm) space on each side and at the top and 2" (51mm)
at the rear. Take care that the air vent at the front of the appliance is never covered or blocked in
anyway.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other
heating source. Direct sunlight may affect the acrylic coating and heat sources may increase
electrical consumption. Don't install in a location where the temperature will fall below 60°F (16°C).
For best performance, do not install the appliance behind a cabinet door or block the base grille.
•
Avoid locating the unit in moist areas.
•
Plug the Beverage Cooler into an exclusive, properly grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
NOTE: Model numbers with "OS" in their suffix feature reinforced construction and can be used in
the outdoors. Extreme temperature conditions may affect performance.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug that mates with standard three-prong wall outlets to minimize
the possibility of electrical shock.
6
Advertisement
Table of Contents
