Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Summit ALFZ51
Summary of Contents for Summit ALFZ51
- Page 1 Instruction Manual Models: ALFZ51 SPFF54OS SCFF54CSS Single-Zone Freezer BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS. KEEP THIS MANUAL IN A SECURE LOCATION. Write Serial Number here: Model No.: Serial No.: _______________________...
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Read all instructions before using the appliance. This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. - Page 3 disconnected. Do not connect or disconnect the electric plug when your hands are wet. Unplug the appliance or disconnect the power before cleaning or servicing. Failure to do so can result in electrical shock or death. Do not attempt to repair or replace any part of your appliance unless it is specifically recommended in this manual.
- Page 4 In the event of any damage: - Avoid open flames and anything that creates a spark, - Disconnect from the electrical power line, - Air the room in which the appliance is located for several minutes and contact the Service Department for advice.
-
Page 5: Installation Instructions
- SAVE THESE INSTRUCTIONS - INSTALLATION INSTRUCTIONS Before Using Your Appliance Remove the exterior and interior packing. Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. Clean the interior surface with lukewarm water using a soft cloth. - Page 6 How to put off the shelves 1. Take out all items from the shelves. 2. Please keep the door open fully all the way before pulling the shelves out. 3. Pull the shelf forwards (Fig.1) until the groove on either side of the shelf is level with the plastic peg on either side of the cabinet.
-
Page 7: Operation
the top of the door. (Fig.2) Remove the bottom support bracket from the right side. (Fig.3) Remove the top right hinge and keep in a safe place in case you want to reverse the door in the future. (Fig.4) Remove the screws from the top left and transfer to the right. Install the top left hinge. - Page 8 If you press and hold the °C/°F button for 3 seconds, the unit will enter the “Fast Freeze” mode. In this mode, press the buttons to set the fast-freezing time. The setting time range is 1 to 10 hours, and the default setting time is 3 hours.
-
Page 9: Care And Maintenance
CARE AND MAINTENANCE Cleaning Your Appliance 1. Turn off the power, unplug the appliance, and remove all items including shelves and racks. 2. Wash the inside surfaces with a warm water and baking soda solution. The solution should consist of about 2 tablespoons of baking soda to a quart of water. -
Page 10: Problems With Your Appliance
PROBLEMS WITH YOUR APPLIANCE You can solve many common problems easily, saving you the cost of a service call. Try the suggestions below to see if you can solve the problem before calling SUMMIT APPLIANCE. To reach SUMMIT’s customer service call: (800) 932-4267 or visit: www.summitappliance.com/support... - Page 11 NOTES & CARB STATEMENT CALIFORNIA CARB/SNAP DISCLOSURE This product uses eco-friendly hydrocarbon refrigerant and fully complies with California CARB regulations. However, we are required by California Law to provide the following disclosure statement in every product sold in California. "This equipment is prohibited from use in California with any refrigerants on the 'List of Prohibited Substances' for that specific end-use, in accordance with California Code of Regulations, title 17, section 95374.
-
Page 12: Limited Warranty
LIMITED WARRANTY ONE-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for one year from the date of purchase, when this appliance is operated and maintained according to instructions attached to or furnished with the product, the warrantor will pay for factory specified parts and repair labor to correct defects in materials or workmanship.