Creating A Back-Up; Application Mode "Remote; Acquire Data And Transfer It To Rf-Manager - Siemens SIMATIC RF310M Operating Instructions Manual

9.1.7

Creating a back-up

Create a back-up to save the settings even in the case of power failure. The steps you have
to perform to do this are described in detail in the Chapter Performing a back-up (Page 24).
9.2

Application mode "Remote"

In application mode "Remote" that is configured via the Engineering System in RF-
-MANAGER, the SIMATIC 310M mobile handheld terminal has the properties of a stationary
reader. This means that the acquired data are only displayed on the reader and transferred
to RF-MANAGER.
You are not able to acknowledge or reject the scanned data in SIMATIC RF310M.
9.2.1

Acquire data and transfer it to RF-MANAGER

Data acquisition
Depending on the configuration in the Engineering System, you can activate an RFID read
operation using the hardware keys or the "Scan" button of SIMATIC RF310M.
If you have configured the reading of RFID tag data, the scanned tag ID will be preceded by
"RFID".
Figure 9-2
A Note symbol is displayed at the bottom right in the display if the data has not yet been
transferred to the RF-MANAGER:
SIMATIC RF310M Mobile Reader
Operating Instructions, 10/2013, J31069-D0191-U001-A6-7618
List of RFID tag IDs (remote).
RF-MANAGER RF310M software
9.2 Application mode "Remote"
63