Shindaiwa PowerBroom PB2500 Operator's Manual page 7

Assembly: Mainshaft/Powerhead
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
See Figure 5.
2. Use the 4mm hex wrench to loosen
the tube clamp screw. Verify that the
D-shaped shim washer is positioned as
shown in Figure 6.
Hex
Wrench
PB2500.04
Figure 6
CAUTION!
Do not remove the D-shaped shim
washer! The shim washer prevents
damage from overtightening the tube
clamp screw.
3. Add some moly-type EP grease to the
splines on the end of the mainshaft.
Assembly: Throttle Linkage and Ignition Leads
Connect the Throttle Cable
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
See Figure 7.
2. Slip the throttle cable into the cable
adjuster and hook the bullet end of the
cable onto the swivel. See Figure 8.
Connect the Ignition Leads
3. Connect the two ignition wires by
pushing the bullet connectors
together. See Figure 9.
4. Reinstall the air cleaner cover.
CAUTION!
Routing of wiring must not interfere
with throttle operation.
PB2500 PowerBroom
Connect the Outer Tube to the
Powerhead
Tube
Clamp
Shim
Washer
Figure 5
4. Slide the outer tube into the tube
clamp until the tube bottoms.
5. Position the outer tube so that the
ignition switch is facing up and the
throttle trigger is down.
CAUTION!
Do not force the shaft tube into the
powerhead! Excessive force can
damage the shaft tube or mainshaft.
Filter
Cover
PB2500.05
Figure 7
PB2500.08
Figure 9
Clamp
Screw
Grip
Ignition
Switch
PB08
Throttle
Trigger
6. Slide the outer tube into the power-
7. Tighten the clamp screw firmly.
Figure 8
Ignition
Lead
Spark
Plug
Main
Shaft
Tube
Clamp
Outer Tube
head until the throttle grip just
contacts the tube clamp.
Connect the throttle
cable
PB2500.06
Throttle
Cable
Adjuster
Cable Swivel
Cable
7