Assembly - Shindaiwa 89300 Owner's/Operator's Manual

Assembly

This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
IMPORTANT!
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Handle and barrier bar X unit
The handle is attached at the factory and
positioned vertically.
1. Loosen socket headed capscrew(s) at
the base of handle and rotate the han-
dle 90 degrees.
NOTE:
Keep handle forward of handle position-
ing label!
2. Position the handle forward of the
Handle Positioning Label at the best
position for operator comfort (usually
about 254 mm (10 inches) ahead of
throttle housing).
3. Tighten the socket headed capscrew
securely.
6
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
X unit
Handle
Outer Tube
Rotate and position handle in best location for operator comfort
Engine and shaft assembly
Cutting attachment shield
Cutting attachment
Kit containing cutting attachment
shield, mounting bracket and hardware,
this owner's/operator's manual and tool
kit for routine maintenance. Tool kits
vary by model and may include a spark
plug/screwdriver combination wrench,
and a scraper.
4 Socket-head
capscrews
Handle position label
Barrier Bar