Operation - Chicago Electric 47937 Assembly And Operating Instructions Manual

1. Place a Guide Shaft (54) into the slot on the Base (47).
2. Insert the Circle Cutting Guide (55) on the Guide Shaft and securely tighten.
3. Adjust the Guide Shaft to the desired distance from the bit (outside) to the Circle
Cutting Guide center point. This distance is the radius of the circle to be cut.
4. Tighten Lock Knob (31).
5. Place the Circle Cutting Guide center point on desired axis point on the stock. Lightly
tap its screw head to cause an indentation on the stock.
Caution: Before operating the router, read these safety tips:
• Wear ANSI approved impact safety goggles.
• Avoid cutting nails.
• Hold router handles firmly with both hands.
• Keep hands away from rotating bit. Wait until it stops, and unplug the line cord,
before making adjustments.
• Don't touch bit right after cutting. It becomes very hot.
• Watch and feel for vibration that could indicate an improperly installed bit.
• Turn router Off when not actually cutting. Do not leave running or unattended.
Read and understand the Controls and Indicators section on page 8 before proceeding.
1. Secure material to be routed.
2. Set router on material to be cut. Verify there are no obstructions in the cutting path.
3. Verify Plunger Locking Lever (35) is loose.
SKU 47937
Using the Circle Cutting Guide
(31)

OPERATION

For technical questions, please call 1-800-444-3353.
(54)
Center Point
(55)
Page 11