Harbor Freight Tools. Diagrams within this manual may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
saVe this Manual Keep this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Page 3
ranges and refrigerators. There is an increased risk of electric shock if your body is grounded. do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. do not abuse the cord. never use the cord for carrying, pulling or unplugging the power tool.
Maintain labels and nameplates on the tool. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement. Avoid unintentional starting. Prepare to begin work before turning on the tool.
• Avoid operating alone. • Do not use with power switch locked • Properly maintain and inspect to avoid electrical shock. • Any power cord must be properly grounded. Ground Fault Circuit Interrupter (GFCI) should also be implemented – it prevents sustained electrical shock.
abnormal vibration occurs, stop use immediately. saVe these instruCtiOns. grOunding tO preVent eleCtriC shOCK and death FrOM inCOrreCt grOunding wire COnneCtiOn: Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. do not modify the power cord plug provided with the tool.
Page 7
Make sure the extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it. Protect the extension cords from sharp objects, excessive heat, and damp or wet areas.
Page 9
Adjuster is a 6-position speed dial switch located on the top/front of the handle. By rotating the Speed Adjuster from 1 to 6, the Saw Blade speed can be set from 800 to 3,000 strokes per minute. power switch (29):...
Chuck (24). Insert the Saw Blade (68, 69) as far as it will go, making sure the teeth of the Saw Blade face to the front of the tool. Then release the clamp button on the Blade Chuck, and close the Plastic Blade Guard.
Operating instructions Plug the Power Cord into the nearest 120 volt, grounded, electrical outlet. Position the Saw Blade (68, 69) of the Jigsaw about 1/2” from the beginning cut line on the workpiece. Do not allow the Saw Blade to come in contact with the workpiece.
SKU 94560 For technical questions, please call 1‑800‑444‑3353. before each use, Blade (68, 69). Using a dull Saw Blade will cause excessive wear on the Motor of the Jigsaw and will not produce a satisfactory cut. Replace with a new Saw Blade when needed.
problem possible Causes Tool will not start. Cord not connected. No power at outlet. Tool’s thermal reset breaker tripped (if equipped). Internal damage or wear. (Carbon brushes or switch, for example.) Tool operates slowly. Extension cord too long or wire size too small.
please read the FOllOwing CareFullY THE MANUFACTURER AND/OR DISTRIbUTOR HAS PROvIDED THE PARTS LIST AND ASSEMbLy DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLy. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANy REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANy PARTS OF THE PRODUCT.
90 daY warrantY Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.