Table of Contents
Advertisement
1.
Pull on the Safety Valve (34) to make sure it moves freely.
(See Figure b, previous page)
2.
Check to make sure the Air Tank's Drain Valve (31), located at the bottom of the
Air Tank (29), is fully closed. (See Figure C)
3.
If the recommended water filter/regulator/oiler setup is implmented. (Figure A)
Connect the air hose (not included) to the oiler outlet. Then connect the other
end of the air hose to the pneumatic tool (not included) being used.
(See Figure b)
4.
Plug the Power Cord (21) into the nearest 120 volt, grounded, electrical outlet.
.
Turn the Power Switch (4) to its "ON" position to start the unit. (See Figure b)
When the Tank Air Pressure Gauge (35) reaches at least 125 PSI, turn the
6.
air Pressure Controller (12) clockwise or counterclockwise to allow the proper
amount of air flow to reach the pneumatic tool being used. (See Figure b)
7.
NOtE: The Regulator adjusts as follows:
•
Clockwise to increase tool air pressure.
•
Counterclockwise to decrease tool air pressure.
.
IMPORtANt: When the maximum air pressure, 155 PSI, is reached as
indicated by the Tank Air Pressure Gauge (35), the Motor will stop. The Air
Compressor will automatically restart when the air pressure drops below 125
PSI.
9.
IMPORtANt: The internal overload protection mechanism will automatically
shut off the Motor if the Motor becomes too hot. in this case, turn the Power
SKU 96496
For technical questions, please call 1-800-444-3353.
General Operating Instructions
Air Tank (26)
Drain Valve (31)
Page 10
Advertisement
Table of Contents
