21 Gallon Cast Iron VErtICal oIl-lubrICatEd aIr CoMPrEssor Model 94667 oPEratInG InstruCtIons Visit our website at: http://www.harborfreight.com read this material before using this product. Failure to do so can result in serious injury. saVE thIs Manual. Copyright 2006 by Harbor Freight Tools .
Wear a protective hair covering to prevent long hair from becoming caught in moving parts. If wearing a long-sleeve shirt, roll sleeves up above elbows. rEV 06l; 07c; 09c, 10a PAGE 2 SKU 94667 For technical questions, please call 1-800-444-3353.
Page 3
The operator must understand that common sense and caution are factors, which cannot be built into this product, but must be supplied by the operator. PAGE 3 SKU 94667 For technical questions, please call 1-800-444-3353.
WarnInG: This product contains or produces a chemical known to the State of California to cause cancer and birth defects (or other reproductive harm). (California Health & Safety Code § 25249.5, et seq.) REV10c PAGE 4 SKU 94667 For technical questions, please call 1-800-444-3353.
The Oil Window (20B) is used to determine if oil is needed. The oil level should always be at the maximum level (red line on the Oil Window). (see Figure C, and assy. diagram b.) rEV 07i PAGE 5 SKU 94667 For technical questions, please call 1-800-444-3353.
Page 6
Allow sufficient time for the Tank Pressure Gauge (4A) to indicate 80 PsI before using the Air Compressor. Turn the Air Flow Valve (6A) to its “ON” position to allow air to the pneumatic tool. PAGE 6 SKU 94667 For technical questions, please call 1-800-444-3353.
Page 7
(10A) until the compressed air and condensation begins to be released from the Air Tank (9A). Allow sufficient time for all of the air and condensation to escape from the Air Tank. Then, firmly retighten the Water Drain Valve. PAGE 7 SKU 94667 For technical questions, please call 1-800-444-3353.
ProduCt or rEPlaCEMEnt Parts thErEto, or arIsInG out oF hIs or hEr InstallatIon oF rEPlaCEMEnt Parts thErEto. PAGE 8 SKU 94667 For technical questions, please call 1-800-444-3353.
Page 9
Air Flow Lid 18A Unloader Valve Air Tank 19A Polyurethane Unloader Tube 10A Water Drain Valve 20A Copper Air Tube (Rear View with motor cover removed.) rEV 07b; 07f; 10d PAGE 9 SKU 94667 For technical questions, please call 1-800-444-3353.
Page 10
*Not available individually. Must be ordered as entire Motor Assembly (See part #34B). notE: Some parts are listed and shown for illustration purposes only, and are not avail- able individually as replacement parts. PAGE 10 SKU 94667 For technical questions, please call 1-800-444-3353.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. 3491 Mission Oaks Blvd. • PO Box 6009 • Camarillo, CA 93011 • (800) 444-3353 PAGE 11 SKU 94667 For technical questions, please call 1-800-444-3353.