Carrier 19XL series Installation Instructions Manual page 18

Note: Wiring must also be disconnected. Label each wire before removal (see Carrier Certified
Prints). In order to disconnect the starter from the machine, remove wiring for the oil
pump, oil heater, control wiring at the power panel, and the main motor leads at the
starter lugs.
Remove all transducer and sensor wires at the sensor. Clip all wire ties necessary to pull
heat exchangers apart.
Click here for Figure 3 — Machine Rigging Guide
Click here for Figure 4 — 19XL Dimensions
Click here for Table 1 — 19XL Compressor/Motor Weights
Click here for Table 2 — 19XL Component Weights
Click here for Table 3 — 19XL Heat Exchanger Weights