Hussmann Q3-DV Installation & Operation Manual page 11

Installation (cont'd)
STEP 4. Apply liberal bead of case joint sealant
(Silicone) to fi rst case. Sealant area is shown in
illustration. Apply heavy amount to cover entire
shaded area. (pg10)
STEP 5. Slide second case up to fi rst case
snugly. Then level second case to the fi rst case
so glass front, bumper and top are fl ush.
STEP 6. To compress butyl at joint, use two
Jurgenson wood clamps. Make sure case is
level from front to back and side to side on inside
bulkheads at joint.
STEP 7. Attach sections together.
STEP 8. Apply bead of butyl to top of bulk heads
and slide on stainless steel bulkhead cap as pic-
tured below. Also apply silicone to seam between
joints.
11
BULK HEAD
JOINT CAPS