Installation; Location; Uncrating The Stand; Exterior Loading - Hussmann DSF Installation & Operation Manual

Installation

Location

The refrigerated merchandisers have been designed for
use only in air conditioned stores where temperature and
humidity are maintained at or below 75°F and 55% relative
humidity. DO NOT allow air conditioning, electric fans, ovens,
open doors or windows (etc.) to create air currents around
the merchandiser, as this will impair its correct operation.
Product temperature should always be maintained at a
• DSFI/N glass is shipped loose to job site due to tip hazard.
constant and proper temperature. This means that from the
• Cases must be set and joined prior to installation of front glass.
time the product is received, through storage, preparation
• High risk of injury if glass is installed prior to finalizing installation.
and display, the temperature of the product must be
• Case front tipping hazard if warning not adhered to.
controlled to maximize life of the product.
Uncrating the Stand (If Provided; Crating is Optional)
Place the fi xture as close to its permanent position as
possible. Remove the top of the crate. Detach the walls
from each other and remove from the skid. Unbolt the case
from the skid. The fi xture can now be lifted off the crate
skid. Lift only at base of stand!
When crating is not provided, lift at one end panel using
forklift and place a dolly under that end panel such that
end panel rests in the middle of the dolly. Repeat the
same procedure at the other end panel. Once the fi xture
is on dollies, move it carefully out of the truck. This is a
recommendation only. Unloading the fi xture following safe
procedures is the responsibility of the company unloading
and installing these fi xtures.

Exterior Loading

These models have not been structurally designed to
support excessive external loading. Do not walk on their
tops; This could cause serious personal injury and damage
to the fi xture.

Setting and Joining

The sectional construction of these models enable them to
be joined in line to give the effect of one continuous display.
A joint trim kit is supplied with each joint.
4