Blocking Unwanted Faxes; Duplex Scanning - Sharp UX-B800 Operation Manual

Blocking Unwanted Faxes

The Anti Junk Fax function blocks
reception of faxes from a fax number
that you specify.
To use this function, enter the fax
number that you want to block. Only one
number can be entered.
FUNCTION
1
Press , then
[
ENTRY MODE] appears
2
Press , then
JUNK #] appears.
3
Press (SET) to store an Anti
Junk number.
(To clear a previously stored
number, press
go to Step 5.)
4
Enter the number with the number
keys (max. 20 digits).
5
Press .
STOP
6
Press to exit.
•
When a fax is blocked (or when a
voice call is blocked if you are using
the Caller ID function), a transaction
report (page 56) will print to inform
you (unless "TRANSACTION LIST"
on page 50 is set to "NEVER
PRINT").
until
.
until [
ANTI
(CLEAR) and
Blocking Unwanted Faxes

Duplex Scanning

Duplex Scanning is convenient for
transmitting or copying two-sided
documents. When this function is
selected, you simply feed all pages of
the document through the machine
once, turn the stack of pages over, and
feed the stack through again. The
machine will automatically sort the
pages into the correct order (front of 1st
page, back of 1st page, front of 2nd
page, back of 2nd page, etc.).
♦
Note that any blank sides must be
included when scanning the pages (if
the number of pages is not equal
each time the machine scans the
stack, an error will result).
1
Load the documents. Make sure the
pages are placed front-side down,
with the first page on the bottom.
•
If desired, press
resolution and/or contrast.
2
Press and then
DUPLEX
3
Perform all steps of the desired copy
or transmission operation.
4
When all pages of the document
have been scanned, turn the stack
over (do not change the page order)
and load the stack again.
5
Press .
RESOLUTION/
RECEPTION MODE
to set the
.
43