Scan To E-Mail Transmission - Sharp UX-B800 Operation Manual

Scan to E-mail Transmission

Scan to E-mail Transmission
Follow the steps below to send a
document to an e-mail recipient.
♦
The document will be sent as an
attachment to an e-mail message.
♦
You can specify the recipient by
directly entering an e-mail address, or
by selecting an address that has been
stored as explained in the previous
section.
1
Flip up the feeder cover (➊) and
adjust the document guides to the
width of your document (➋).
2
Insert the document face down with
the top edge going in first.
Up to 20 A4-size sheets can be
placed in the feeder at once.
•
For more information on loading the
document, see page 26.
22
2
1
•
If desired, press
resolution and contrast (see p. 27).
3
Enter the destination e-mail address
using one of the following methods:
•
Press
, and enter the address with the
letter and number keys (p. 6). When
finished, press
•
If the address has been stored in the
A, B, or C key, press the key.
•
If the address has been stored in a
Rapid Key, press the Rapid Key.
•
If the address has been stored in a
Speed Dial number, press
and enter the Speed Dial number.
•
To search for a stored address, press
stored fax numbers from the search),
press or
or address appears, and press
.
Note: If [CHECK E-MAIL SETTING]
appears, your SMTP server or
sender address has not been
entered in the e-mail settings (p. 17).
RESOLUTION/
RECEPTION MODE
to set the
, press
.
SPEED DIAL
(this eliminates
until the name