Viessmann VITODENS 200-W Type B2HA Technical Manual page 53

Design information
An installation template is supplied with the Vitodens 200-W to mark
the position of the screws for the wall mounting bracket and the loca-
tion of the flue pipe on the wall.
Connection sets for the connection of the heating circuits and a
DHW cylinder must be ordered separately.
A Reference point Vitodens top edge
B Vitodens installation template
C Area for power cables
Allow cables to protrude approx. 1200 mm from the wall.
Boiler
a mm
Self-supporting installation with a self-supporting mounting
frame (single boiler)
The Vitodens can be mounted on the self-supporting mounting
frame.
VITODENS 200-W
(cont.)
4 8
0
4 2
2
Ø 10
E
C
2 0
0
49 - 60 kW 80 - 99 kW
138
A
B
F
D Recommended dimension for a single boiler system
E Wall mounting bracket
F Top edge finished floor
The mounting bracket supplied with the boiler cannot then be used.
268
4
VIESMANN
53