Sheets Cannot Be Stapled Properly - Ricoh TCRU/ORU Troubleshooting Manual

Trailing edge
too near exit
Output tray
Paper feed direction
Solution:
1. Load the sheets the other way up.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
To follow the steps below, attach the decurler unit.
3. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0304: [Correct Output Paper Curl] to " Curl Correction Level".
Select "Large" or "Small" to control the level of decurling as required.
4. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.

Sheets Cannot Be Stapled Properly

Cause:
When the sheets are fed to the staple unit inside the finisher, they may be overlaid, resulting in a
misalignment of 5 mm (0.2 inches) relative to each other after stapling.
When coated or other paper producing higher paper-to-paper friction is used, the paper edges are not
aligned properly, resulting in misaligned stapling.
This may occur if:
Paper exit
CEZ593
Finisher
135