Table of Contents
Advertisement
SPECIFICATIONS
Max capacities
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
.....................Wear safety glasses.
Intended use
The tool is intended for polishing, smoothing before
painting, finishing surfaces, and removing rust and paint.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the oper-
ator from electric shock. Use only three-wire extension
cords which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
2
Model
Sponge pad/ Wool bonnet
Abrasive disc
-1
)
Overall length
Net weight
END101-1
PV7001
180 mm
180 mm
1,700
210 mm
2.0 kg
PV7001C
180 mm
180 mm
600 - 2,000
210 mm
2.0 kg
Advertisement
Table of Contents
