Placing The Original On The Document Glass - Sharp MX-C311 Operation Manual

PLACING THE ORIGINAL ON THE DOCUMENT GLASS

This section explains how to place the original on the document glass.
Allowed original sizes
Maximum original size
Standard sizes
8-1/2" (height) x 11" (width)
A4: 210 mm (height) x 297 mm (width)
Non-standard sizes
8-1/2" (height) x 11-11/16" (width)
216 mm (height) x 297 mm (width)
1
2
3
BEFORE USING THE MACHINE
When the original is a non-standard size, see the
appropriate explanation below for the mode you are
using.
☞
2. COPIER "SPECIFYING THE ORIGINAL
(page 2-29)
☞
4. FACSIMILE
☞
5. SCANNER / INTERNET FAX
SETTINGS" (page 5-49)
Open the automatic document feeder.
Place the original.
Place the original face down in the left center position of the
document glass.
Document glass scale
mark
5-1/2" x 8-1/2"
(A5)
B5
8-1/2" x 11" (A4)
All originals should be placed in the left center position.
Align the middle of the original with the tip of the
Close the automatic document feeder.
After placing the original, be sure to close the automatic
document feeder. If left open, parts outside of the original will
be copied black, causing excessive use of toner.
1-36
"IMAGE SETTINGS" (page 4-43)
"IMAGE
Contents
SIZE"
mark.