Sharp FO-DC535 Network Manual page 34

Administrator Password
Changing the Password Protect setting
Follow the steps below if you need to change the Password Protect setting
(enable or disable password protection).
1
Press the following sequence of keys:
MENU
,
•
This is a hidden operation, and therefore error beeps may sound and the
display may not respond normally when you press several of the above
keys. Disregard the error beeps and display while pressing the keys.
•
If password protection is enabled, a password entry screen will appear after
you press
password.
2
Press
PROTECTION and press
3
To enable protection (require entry of
the password), press
and press
To disable protection, make sure that
NO is selected and press
4
Press the numeric keys and/or the letter keys to enter the password.
5
When you have finished entering the password, press
When password protection is enabled
When password protection enabled, you will be prompted to enter the
password each time you press
the password with the numeric and/or letter keys as appropriate, press
and then continue as usual.
32
COPY
START/
, , , 1 ,
ENTER
MENU
. Continue to press the above keys without entering the
to select PASSWORD
START/
ENTER
to select YES
START/
.
ENTER
START/
ENTER
Display:
ADMIN PASSWORD
1:PASSWORD SET
.
2:PASSWORD PROTECTION
ADMIN PASSWORD
PASSWORD PROTECTION
1=YES
.
2=NO
ADMIN PASSWORD
[
ENTER PASSWORD
.
MENU
to configure a MENU setting. Enter
]
START/
.
ENTER
START/
,
ENTER