Toshiba Satellite U840 Maintenance Manual page 183

Chapter 4 Replacement Procedures
4.18 LED board
Removing the LED board.
The following describes the procedure for removing the touch pad (See Figure 4-18-1 to 4-
18-2).
1. Remove screws M2.0x2.5-I (BUWZN) x2PCS and disassemble LED board.
2. Disconnect LED FFC from LED board connector.
Figure 4-18-1 Remove screws M2.0x2.5-I (BUWZN) x2PCS and disassemble LED board
Figure 4-18-2 Disconnect LED FFC from LED board connector.
56
Satellite U840 Maintenance Manual (960-Q08)