Dukane 8142WISS User Manual page 8

Connecting with your devices (continued)
CAUTION ►Before you insert or pull out the USB wireless adapter from
the projector, turn off the power of the projector and pull out the power cord's
plug from the outlet. Do not touch the USB wireless adapter while the projector
is receiving AC power.
NOTICE ►Use the cables with straight plugs, not L-shaped ones, as the input
ports of the projector are recessed.
Ferrite core for MHL cable
When connecting a MHL cable to this projector, attach the ferrite core that is
supplied with the projector to the MHL cable.
Refer to the following figure to attach the core to the cable nearby one end of the
cable firmly, and secure it using the cable tie.
Be sure to connect the end of the cable to the projector.
MHL cable
Ferrite core
Fastening the adapter cover
Use the supplied adapter cover to prevent the
USB wireless adapter (optional) from coming
off easily and prevention from burn injury.
1.
Loosen the screw (marked with triangle)
on the bottom left of the USB TYPE A port.
2.
Insert the tab of the cover into the hole
at the upper right of the USB TYPE A
port in the direction of the arrow.
3.
Align the screw holes on the projector
and the cover. Then insert the screw
removed from the projector into the hole
and tighten the screw.
WARNING ►Keep small parts away from children and pets. Take care not to
put in the mouth. Heat may build up in the USB wireless adapter, so disconnect
the projector power cord for more than 10 minutes before touching it to avoid
possible burns.
8
Cable tie - small
Projector
Ferrite core
MHL
1
3
2
Tab