Arrangement - Dukane 8142WISS User Manual

Contents of package (continued)
NOTE • About the StarBoard Software, read the manuals that are provided
in the disc of the software.
• StarBoard Software complies with the conditions provided by StarBoard
Solution Ltd. Contact your local dealer or service company for inquiry.

Arrangement

Refer to tables T-1
screen size and projection distance.
The values shown in the table are calculated for a full size screen.
Screen size (diagonal)
a
• For the case of installation in special conditions such as on the wall or ceiling, the
specified mounting accessories (
projector, consult your dealer about your installation.
• The screen position may shift after installation if the projector is mounted on locations
such as the wall or ceiling, due to the flexibility of the plastic projector body. If readjustment
is necessary, consult with your dealer or service personnel.
• The projected image position and/or focus may change during warm-up (approx. 30
minutes after the light source is turned on) or when the ambient conditions change.
Readjust the image position and/or focus as necessary.
• Since the projector features an ultra short throw, be aware that it is required to select a
screen carefully to have better performance.
- A soft screen such as a pull-down screen may cause serious distortion of a projected
image. A hard screen such as a board screen is recommended for use with this projector.
- A high-gain screen such as a bead screen that has narrow viewing angle is not suitable
for this projector. A low-gain screen (around 1.0) such as a matte screen that has wide
viewing angle is recommended for use with this projector.
- A screen with a weave pattern may cause moire on the projected image, which is not a failure
of the projector. A screen that has less moire effects is recommended for use with this projector.
WARNING ►Install the projector in a stable horizontal position.
►Place the projector in a cool place, and ensure that there is sufficient ventilation.
Keep a space of 50 cm or
such as walls. Do not place or attach anything that would block the projection
window, camera lens or vent holes. Do not place the projector where the air from an
air conditioner or similar unit will blow on it directly.
►Do not place the projector anyplace where it may get wet.
►Use only the mounting accessories the manufacturer specified, and leave installing
and removing the projector with the mounting accessories to the service personnel.
►Read and keep the user's manual of the mounting accessories used.
CAUTION ►Avoid placing the projector in smoky, humid or dusty place.
►Position the projector to prevent light from directly hitting the projector's remote sensor.
►Do not touch the camera lens with your fingers.
NOTE • Installation position, picture mode, altitude, and operating environment
may affect the brightness of the display.
6
and figures F-1 and F-2 at the end of this manual to determine the
Projection distance (±8%)
b1 , b2
18) and service may be required. Before installing the
more between the sides of the projector and other objects
, Screen height (±8%)
c1 c2