Kenwood ProTalk TK-3501 Instruction Manual page 20

CHANNEL OPERATING FREQUENCIES
To change the operating frequency of a channel:
1 Select your desired channel using the Channel selector.
2 With the transceiver power OFF, press and hold the PTT
switch while turning the transceiver power ON.
• Continue to hold the PTT switch until the LED lights orange
(approximately 2 seconds).
3 Release the PTT switch.
• The transceiver emits a morse code of the current channel
setting. Refer to the table below for the morse code output.
4 Press and hold the Side key for 1 second to change the 10's
digit of the Channel Setup number to 0. Press the Side key to
change the 10's digit of the Channel Setup number to 1.
• Channel Setup numbers and their corresponding operating
frequencies are provided in the table. {p.13}
• After 1 second, the transceiver will emit a morse code of the
current Channel Setup setting.
5 Press and hold the Side key for 1 second to change the 1's
digit of the Channel Setup number to 0. Press the Side key to
change the 1's digit of the Channel Setup number to (1 ~ 9).
• After 1 second, the transceiver will emit a morse code of the
current 1's digit Channel Setup number setting.
6 Press the PTT switch to save the setting.
• The LED will blink red and a beep will sound.
• The transceiver will automatically return to normal operation
when no action is performed for approximately 6 seconds.
Setting
Number
0
1
2
3
4
12
Morse Code
—
• —
• • —
• • • —
• • • • —
Setting Number
5
6
7
8
9
Morse Code
• • • • •
— • • • •
— • • •
— • •
— •