Kenwood ProTalk TK-3501 Instruction Manual page 12

CHARGING THE BATTERY PACK
The battery pack is not charged at the factory; charge it before
use.
ATTENTION:
◆ Always switch OFF a transceiver equipped with a battery pack
before inserting the transceiver into the charger.
1 Plug the AC adapter cable into
the jack located on the rear of
the charger.
2 Plug the AC adapter into an AC
outlet.
3 Slide a battery pack or a
transceiver equipped with a
battery pack into the charging
slot of the charger.
• Make sure the metal contacts of
the battery pack mate securely
with the charger terminals.
• The indicator lights red and
charging begins.
4 When charging is completed,
the indicator lights green.
Remove the battery pack or the
transceiver from the charging
slot of the charger.
• It takes approximately 3 hours to
charge the battery pack.
• When the charger will not be
used for a long time, unplug the
AC adapter from the AC outlet.
4
Charging slot
Indicator