INSTALLING THE BELT CLIP
1 Remove the battery pack. {p. 2}
2 To install the belt clip, align the
guides of the belt clip with the
grooves on the rear of the battery
pack, then slide the belt clip into
place until the lock lever is secure.
3 To remove the belt clip, push the
lock lever towards the transceiver
while sliding the belt clip up.
INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE
JACKS
If you are not using a speaker/
microphone or Headset, install the
cap over the speaker/ microphone
jacks using the supplied M3 x 6 mm
screws.
Note:
◆ To keep the transceiver water
resistant, you must cover the
speaker/ microphone jacks with the
supplied cap.
Belt clip
Lock lever
cap
3