Hdd; Before Removing The Hdd; Removing The Hdd; When Replacing The Hdd - Canon Color iR C3480 Service Manual

[1]
[1]
2) Open the fixing member in the direction shown by the arrow, and then re-
move the image memory (SDRAM) PCB [1].
In case the 2 image memories (SDRAM) are attached, remove both of them.

4.7.11 HDD

4.7.11.1 Before Removing the HDD

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
C3080i / iR C2550
1) Detach the rear upper cover. (page 10-18)[Detaching the Rear Upper
Cover]

4.7.11.2 Removing the HDD

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
C3080i / iR C2550
1) Detach the main controller cover [1].
- 1 wire saddle [2]
- 14 screws [3]
[2] [1]
[2] [1]
F-4-36
[1]
F-4-37
[1]
F-4-38
[2]
[3]
2) Remove the HDD unit [1].
- 2 connectors [2]
- 1 wire saddle [3]
- 6 screws [4]
Points to Note when Removing the HDD
- When removing the HDD, be sure not to damage it by electrostatic dis-
charge.
- Do not give a shock to the HDD.
[4]
[1]

4.7.11.3 When Replacing the HDD

Color iR C3380G / Color iR C2880G / Color iR C3380i / Color iR C3380 /
Color iR C2880i / Color iR C2880 / iR C3480 / iR C3480i / iR C3080 / iR
0013-6788
C3080i / iR C2550
1. If NetSpot Accountant (NSA) Is Not Used
1) Formatting the HDD
While holding down the 2 and 8 keys on the control panel, turn on the
power to start up. Using the HD formatting function of the SST, format
all partitions.
2) Downloading the Software
Using the SST, download the various software (system, language, RUI).
0013-6787
The machine will take about 10 min to start up after downloading.
2. If NetSpot Accountant (NSA) Is Used Together with a Card Reader
The card ID used by the NSA resides on the HDD. If you have replaced the
HDD, therefore, you will have to newly download the card data from NSA
to enable the statistical operations of NSA. After going through steps 1) and
2) above, perform the following:
1) Set the following in service mode:
Select the following : COPIER >FUNCTION >INSTALL >CARD; then,
enter the number of the first card, and press [OK].
[3]
[1]
[3]
F-4-39
[2] [3]
[4]
F-4-40
Chapter 4
[3]
0014-3124
4-23