Doing A Frequency Check - Sennheiser SK 5212 Instructions For Use Manual

!
The transmitter can only be switched off when the lock mode is
deactivated (see "The automatic lock mode (autolock function)" on
page 13).
Note:
!
When in the setting mode of the operating menu, the
will cancel your entry (ESC function).

Doing a frequency check

The transmitter has a frequency check mode that prevents the transmitter
transmitting on an unwanted frequency after switch-on.
To change the transmission frequency, proceed as follows:
Release the ON/OFF
Immediately (i.e. within five seconds) press the multi-function
switch (switch position SET) twice.
You are now in the setting mode of the "CHAN" or "TUNE" menu where
you can change the transmission frequency (see "Adjustment tips for
the operating menu" on page 21).
To switch the transmitter off, press the
ON /OFF
the LC display panel
The red LED
off.
W hen switching on the transmitter, keep
the
The current frequency is displayed on the
LC display panel
ter actually transmitting.
If the displayed frequency is the correct
one, release the
After five seconds, "RF"
the LC display panel and the transmitter
is transmitting.
RF
MHz
button .
button until "OFF" appears on
and the LC display panel go
ON/OFF button
without the transmit-
ON/OFF
.
ON/OFF button
pressed.
button .
appears on
11