Doing A Frequency Check; The Automatic Lock Mode (Autolock Function) - Sennheiser SK 5212-II - 09-09 Instruction Manual

Using the bodypack transmitter

Doing a frequency check

The transmitter has a frequency check mode that prevents the transmitter transmitting on an
unwanted frequency after switch-on.
MHz
To change the transmission frequency, proceed as follows:
Release the ON/OFF
Immediately (i.e. within five seconds) press the multi-function switch
SET) twice.
You are now in the setting mode of the "CHAN" or "TUNE" menu where you can change the
transmission frequency (see "Adjustment tips for the operating menu" on page 21).

The automatic lock mode (autolock function)

The transmitter has an autolock function (automatic lock mode) that can be activated or
deactivated via the "LOCK" menu (see page 25). When the autolock function is activated, the
lock mode is automatically activated 10 seconds after pressing the last button.
MHz
The autolock function can be deactivated permanently (see page 25) or temporarily (see
page 13).
12
When switching on the transmitter, keep the ON/
OFF button
The RF signal is deactivated. The current frequency is
displayed on the LC display panel
If the displayed frequency is the correct one, release the
ON/OFF
After five seconds, "RF"
panel and the RF signal is activated.
RF
button .
Prior to this, the lock mode icon
RF
the LC display panel
being activated and, at the same time, the display
backlighting goes off.
4
pressed.
button .
appears on the LC display
, indicating that the lock mode is
.
(switch position
flashes several times on