Sealing The Soft Starter (Optional) - Siemens SIRIUS 3RW55 Manual

6.3

Sealing the soft starter (optional)

Requirements
● Seal, sealing wire and a suitable sealing tool
Procedure
1. Push the wire through the openings provided.
2. Seal the wire to secure the hinged cover against unauthorized opening.
Result
By sealing the hinged cover, the interface cover of the 3RW5 HMI High Feature is protected
against unauthorized access. In addition, the 3RW5 HMI High Feature and the
communication module (where present) are protected against unauthorized removal. It is still
possible to operate the 3RW5 HMI High Feature.
Tip
If you install the 3RW5 HMI High Feature outside of the soft starter, use an anti-tamper seal
on the interface cover to protect the local interface and the slot of the micro SD card from
unauthorized access. Proceed in the same sequence as for sealing the spring flap.
For more information, see Chapter Design and operator controls of the High Feature 3RW5
HMI (Page 151).
SIRIUS 3RW55 soft starter
Manual, 08/2018, A5E35630887002A/RS-AB/002
Commissioning
6.3 Sealing the soft starter (optional)
77