Additional Parameters - Siemens SIRIUS 3RW55 Manual

7.14

Additional parameters

Operating principle
The soft starter has additional parameters.
Requirements
● Access protection to HMI module High Feature is not active or has been reset.
● You are in menu "Parameters > Soft Starter > Additional parameters".
Parameters
Parameters
Operation with CPU / Master
Response to CPU / Master Stop
Substitute value*
SIRIUS 3RW55 soft starter
Manual, 08/2018, A5E35630887002A/RS-AB/002
Description
The 3RW55 soft starter sets the control commands internally in the process
image output according to the user-parameterized setting.
Last value
The soft starter does not modify the process image output. The current control
commands are retained.
Substitute value (factory setting)
The process image output is automatically changed by the the soft starter to
the values specified in the following "substitute value" parameter.
This parameter is only visible if the "substitute value" is selected in the
parameter "Response to CPU / Master Stop".
In the event of a bus failure, the 3RW55 soft starter can be controlled by a
corresponding substitute process image output (depending on the 3RW55 soft
starter).
Motor CW
•
Motor CCW
•
Reset
•
Emergency start
•
Creep speed
•
Output 1
•
Output 2
•
Parameter set bit 0
•
Parameter set bit 1
•
Disable Quick-stop
•
Output 3
•
Pump cleaning
•
Manual operation local - input controlled
•
Use alternative stopping mode
•
Motor standstill
•
Functions
7.14 Additional parameters
143