Care And Cleaning - Cleveland SSE-25-L Installation, Operation And Repair Manual

Tri-leg electric self-contained kettle
Table of Contents

Advertisement

9.
Pour the contents of the kettle into an
appropriate container by opening the
draw-off valve or tilting the kettle
forward. Care should be taken to pour
slowly enough to avoid splashing off the
product.
NOTE: As with cleaning food soil from
any cookware, an important pan of kettle
cleaning is to prevent food from drying
on. For this reason, cleaning should be
completed immediately after cooked
foods are removed. Refer to the "Care
and Cleaning Instructions" for detailed
kettle washing procedures.
TEMPERATURE RANGE CHART
Temperature
Control
°F
Setting
Minimum
1
2
3
4
5
6
7
8
9
Maximum
* Certain combinations of ingredients will result in
temperature variations.

CARE AND CLEANING

Your kettle must be cleaned regularly to
maintain its fast, efficient cooking
performance, and to ensure its continued safe,
reliable operation.
* Approx. Product
Temperature
°C
120
49
130
54
145
63
160
71
170
77
185
85
195
91
210
99
230
110
245
118
260
127
WARNING: Do not use chloride base
detergents.
1.
Prepare a warm water and mild detergent
solution in the kettle.
2.
Remove food soil inside the kettle using
a nylon brush. Do not use a metal bristle
brush, as this may permanently damage
the kettle's stainless steel surface.
3.
Loosen food which is stuck to the kettle
by allowing it to soak at a low setting.
4.
If the kettle is equipped with a draw-off
valve, it should be cleaned as follows:
a.
Remove the drain screen from the
bottom of the kettle. Thoroughly
wash and rinse the screen either
in a sink or a dishwasher, then
replace it into the kettle.
b.
Disassemble the draw-off valve
first by turning the valve knob
counter-clockwise, then turning
the large hex nut counter-
clockwise until the valve stem is
free of the valve body.
c.
In a sink, wash and rinse the
valve stem, hex nut and knob.
Wash and rinse the inside of the
valve body using a nylon brush.
d.
Reassemble the draw-off valve by
reversing the procedure for
disassemble. The valve's hex nut
should be hand tight only.
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents